Remove the solenoid valve connector (B) and the oil temperature sensor (A).
9.
Remove the valve body assembly (A).
Tightening torque:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
Installation
1.
Install in the reverse order of removal.
•
Adding Automatic Transaxle Fluid(ATF).
(Refer to "Fluid" in Hydraulic System of this group)
•
Perform Transaxle Control Module(TCM) learning after
replacing the valve body to prevent slow transaxle response, jerky
acceleration and jerky startup.
(Refer to "Repair procedures" in Automatic Transaxle Control System of this group)
Description
The valve body is essential to automatic transaxle control
and consists of various valves used to control the oil feed from the oil
pump. Specifically, these valves consist of press ...
Input Speed Sensor: Repair procedures
Inspection
1.
Check signal waveform of Input & output speed sensor using the GDS.
Specification: Refer to "Signal Wave Form" section.
Removal
1.
Remove the valve body assembly.
(R ...
Troubleshooting
TPMS Inspection method
Inspection
Find the inspection number by referring to the table above.
The following content is irrelevant of the inspection procedure.
1.
...