Inspection |
1. |
Turn ignition switch OFF. |
2. |
Remove the air duct (A). |
3. |
Remove the air cleaner assembly.
|
4. |
Disconnect the solenoid valve connector (A). |
5. |
Measure resistance between sensor signal terminal and ground terminal. |
6. |
Check that the resistance is within the specification. |
Removal |
1. |
Change the shift lever to "N" range. |
2. |
Remove the valve body assembly.
(Refer to "Valve Body" in Hydraulic System) |
3. |
Disconnect the input & output speed sensor connector (A). |
4. |
Loosen the main connctor bolt (B).
|
5. |
Dissconnect the solenoid valve connector (A). |
6. |
Remove the solenoid valve connector clip (B) after loosening a bolt and then remove the connector by pushing down to it. |
Installation |
1. |
Install in the reverse order of removal.
|
Rear Seat: Repair procedures
Replacement
Seat Assembly Replacement
1.
After loosening the mounting bolt, then remove the rear seat cushion (A).
Tightening torque :
49.0 ~ 63.7 N.m (5.0 ~ 6.5 kgf.m, 36.2 ~ 47.0 lb-ft)
...
Front headrest
The driver's and front passenger's seats are equipped with a headrest for the
occupant's safety and comfort.
The headrest not only provides comfort for the driver and front passenger, ...