The Output Speed Sensor is a vital unit that measures the
rate of rotation of the transmission''s turbine shaft and output shaft,
and delivers the readings to the TCM.
The sensor provides critical input data that''s used in
feedback control, damper clutch control, gear setting control, line
pressure control, clutch activation pressure control, and sensor fault
analysis.
Inspection
1.
Check signal waveform of Input & output speed sensor using the GDS.
Specification: Refer to "Signal Wave Form" section.
Removal
1.
Remove the valve body assembly.
(R ...
Specifications
? Type: Hall effect sensor
Operation condition (°C)°F(-40~150) -40~302Air gap (mm)in.(0.25~0.70) 0.0098~0.0276Output voltage (V)High1.18 ~ 1.68Low0.59 ~ 0.84
...
Other Information:
To unfasten the rear center belt
1.Press the release button on the buckle (D) and remove the tongue plate (B)
from the buckle (D).
2.To retract the rear center seatbelt, insert the tongue plate or similar small
rigid device ...
Intercooler: Repair procedures
Removal and Installation
1.
Disconnect the battery negative terminal (A).
Tightening torque
4.0 ~ 6.0N.m (0.4 ~ 0.6kgf.m, 3.0 ~ 4.4lb-ft)
2.
Remove the air cleaner assembly.
(1)
Remove ...