Kia Optima Manuals

Kia Sportage: Output Speed Sensor: Repair procedures - Automatic Transaxle Control System - Automatic Transaxle System - Kia Sportage SL Service & Repair ManualKia Sportage: Output Speed Sensor: Repair procedures

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Automatic Transaxle System / Automatic Transaxle Control System / Output Speed Sensor: Repair procedures

Inspection
1.
Check signal waveform of Input & output speed sensor using the GDS.
Specification: Refer to "Signal Wave Form" section.
Removal
1.
Remove the valve body assembly.
(Refer to "Valve Body" in Hydraulic System of this group)
2.
Disconnect the input & output speed sensor connector (A) from the main wiring.
3.
Remove the input & output speed sensor (B) after removing the bolts(2ea).
Tightening torque :
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Installation
1.
Install in the reverse order of removal.
   
•
Adding Automatic Transaxle Fluid (ATF).
(Refer to "Fluid" in Hydraulic System of this group)
•
Use new valve body gasket (A).

Output Speed Sensor: Troubleshooting
Signal Waveform Fig 1) Input/Output speed sensor at low speed Fig 2) Input/Output speed sensor at high speed ...

Torque Converter Control Solenoid Valve (T/CON_VFS): Description and Operation
Description Torque converter control solenoid valve (T/CON_VFS) is attached to the valve body. This variable force solenoid valve directly controls the hydraulic pressure inside the torque conv ...

Other Information:

Tight corner brake effect
Tight corner brake effect is a unique characteristic of four-wheel drive vehicles caused by the difference in tire rotation at the four wheels and the zero-degree alignment of the front wheels and ...

Pressure Sensor: Repair procedures
Inspection     If you have trouble code related to the pressure sensor (P1825, P1826, P1827, P1828), check pressure sensor according to the inspection process. Pre ...

Categories


Copyright © www.kispmanual.com 2014-2024