Inspection |
1. |
Turn ignition switch OFF. |
2. |
Remove the air duct (A). |
3. |
Remove the air cleaner assembly.
|
4. |
Disconnect the solenoid valve connector (A). |
5. |
Measure resistance between sensor signal terminal and ground terminal. |
6. |
Check that the resistance is within the specification. |
Removal |
Replacing an on/off solenoid valve (SS-A, SS-B) does not
require additional hydraulic pressure adjustment; however, the hydraulic
pressure will need to be adjusted after replacing the VFS solenoid
valve. If replacing the VFS solenoid valve; also replace the valve body
assembly.
(Refer to "Valve Body" in Hydraulic System of this group) |
Rear combination lamp: Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Loose screws (2EA) holding the rear combination lamp then
disconnect the connector (A) then remove the outside rear combination
...
Floor mat anchor(s)
When using a floor mat on the floor carpet, make sure it attaches to the floor
mat anchor(s) in your vehicle. This keeps the floor mat from sliding forward.
The following must be observed when in ...