Inspection |
1. |
Turn ignition switch OFF. |
2. |
Remove the air duct (A). |
3. |
Remove the air cleaner assembly.
|
4. |
Disconnect the solenoid valve connector (A). |
5. |
Measure resistance between sensor signal terminal and ground terminal. |
6. |
Check that the resistance is within the specification. |
Removal |
Replacing an on/off solenoid valve (SS-A, SS-B) does not
require additional hydraulic pressure adjustment; however, the hydraulic
pressure will need to be adjusted after replacing the VFS solenoid
valve. If replacing the VFS solenoid valve; also replace the valve body
assembly.
(Refer to "Valve Body" in Hydraulic System of this group) |
Limp home (override) procedure
When you turn the ignition switch to the ON position, if the immobilizer indicator
() goes off after blinking 5 times,
your transponder equipped in the ignition key is out of order. You cannot sta ...
Troubleshooting
Troubleshooting
Vehicle inspection
SYMPTOM CHART
SymptomSuspect AreaRemedy (See page)Squeak
or grunt-noise from the front suspension, occurs more in cold ambient
temperatures-more noticeabl ...