Inspection |
1. |
Turn ignition switch OFF. |
2. |
Remove the air duct (A). |
3. |
Remove the air cleaner assembly.
|
4. |
Disconnect the solenoid valve connector (A). |
5. |
Measure resistance between sensor signal terminal and ground terminal. |
6. |
Check that the resistance is within the specification. |
Removal |
1. |
Remove the under cover (A).
|
2. |
Remove the drain plug (A) and drain the ATF totally and then reinstall the drain plug.
|
3. |
Remove the air duct (A). |
4. |
Remove the air cleaner assembly.
|
5. |
Disconnect the clip (A) from the valve body cover. |
6. |
Remove the air breather hose (A). |
7. |
Remove t he valve body cover (B).
|
8. |
Remove the solenoid valve connector (B) and the oil temperature sensor (A). |
9. |
Remove the solenoid valve (B) after removing the solenoid support bracket (A).
|
Installation |
1. |
Installation is the reverse of removal.
|
Side impact air bag
Your vehicle is equipped with a side impact air bag in each front seat.
The purpose of the air bag is to provide the vehicle's driver and/or the front
passenger with additional protection t ...
Illuminated ignition switch
Whenever a front door is opened, the ignition switch will illuminate for your
convenience, provided the ignition switch is not in the ON position. The light will
go off immediately when the igni ...