Replacement |
1. |
Remove the driveshaft assembly. (RH side)
(Refer to "Front Driveshaft" in Driveshaft and axle) |
2. |
Remove the dust cover (A). |
3. |
Remove the oil seal (A, B). |
4. |
Install the oil seal with special service tools.
|
5. |
Install the new dust cover (A). |
6. |
Add to transfer fluid.
(Refer to "Transfer Fluid" in Front Wheel Transfer Assembly of this group) |
7. |
Install the drive shaft assembly. (RH side)
(Refer to "Front Driveshaft" in Driveshaft and axle) |
1. |
Remove the transfer assembly from the transaxle assembly.
(Refer to "Front Wheel Transfer Assembly" in this group) |
2. |
Remove the oil seal (A). |
3. |
Install the oil seal with special service tools (09473-3B100).
|
4. |
Add to transfer fluid.
(Refer to "Transfer Fluid" in Front Wheel Transfer Assembly of this group) |
5. |
Install the transfer assembly.
(Refer to "Front Wheel Transfer Assembly" in this group) |
CVVT Oil Control Valve (OCV): Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the OCV connector.
3.
Measure resistance between the OCV terminals 1 and 2.
4.
Check that the resistance is within the specifi ...
If the engine overheats
If your temperature gauge indicates overheating, you experience a loss of power,
or hear loud pinging or knocking, the engine will probably be too hot. If this happens,
you should:
1.Pull off the ...