All units are filled up with coupling fluid (ultra-low
viscosity ATF) prior to shipping. Inspection, fill-up, and replacement
of coupling fluid is therefore not necessary (zero maintenance, lifetime
fluid).
Removal
Coupling Maintenance Precautions
Maintain the coupling at a horizontal level.
•
Refer to the handling caution level (A) when servicing the coupling (removal, installation, replacement, etc.).
•
Remove the dipstick and then mount the coupling assembly to the rear differential assembly.
•
Maintain the coupling at a horizontal level after removing the dipstick to prevent the fluid from spilling out.
1.
Remove the 4WD coupling assembly bolts (A-3ea) mounted to the rear propeller shaft (B).
Tightening torque :
49.0~68.6N.m (5.0~7.0kgf.m, 36.2~50.6lb-ft)
2.
Using a flat tool, separate the propellar shaft from 4WD coupling assembly.
3.
Remove the electric magnetic clutch connector(A).
4.
Remove the 4WD coupling assembly mounting bolts (A-4ea).
Tightening torque :
58.8~63.7N.m (6.0~6.5kgf.m, 43.4~47.0lb-ft)
5.
Using a flat tool, separate the 4WD coupling assembly from the rear differential carrier assembly.
Installation
1.
Installation is the reverse of removal.
•
Grease the spline hole (A) of the coupling assembly.
When installation the coupling, be careful not to damage the oil seal (B).
After replacing the coupling, reset the 4WD ECU''s clutch
learing using the GDS tool. (Refer to " Coupling assembly " in 4WD
group)
Adjustment
Description
The friction material inside the coupling will degrade over
time. Therefore, corresponding compensation values must be referenced
and entered after replacing the controller or the coupling.
Compensation Requirement and Procedure
1.
Simultaneous replacement of 4WD ECU (Controller) and coupling
–
Does not require compensation.
2.
Replacement of coupling only
–
Reset the 4WD ECU''s (Controller) clutch learing.
3.
Replacement of 4WD ECU (Controller) only
–
Before replacement: Check the ECU''s clutch learing.
–
After replacement: Enter the original ECU''s clutch learing into the replacement ECU.
Description
The 4WD ECM controls the Pump Motor Pump (Actuator) to
generating an oil pressure. The pressure engages a multiple disk clutch
to transfer torque to the rear wheels. The torque to t ...
Other Information:
Emergency tailgate safety release
Your vehicle is equipped with an emergency tailgate safety release lever located
on the bottom of the tailgate. When someone is inadvertently locked in the cargo
area, the tailgate can be opened ...
ETC (Electronic Throttle Control) System: Troubleshooting
Fail-Safe Mode
ItemFail-SafeETC MotorThrottle valve stuck at 5°TPSTPS 1 faultECM looks at TPS2TPS 2 faultECM looks at TPS1TPS 1,2 faultThrottle valve stuck at 5°APSAPS 1 faultECM looks at APS 2AP ...