Replacement |
1. |
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported. |
2. |
Remove the front wheel and tire (A) from front hub.
|
3. |
Remove the brake caliper mounting bolts, and then hold the brake caliper assembly (B) with wire.
|
4. |
Remove castle nut (A) from the front hub.
|
5. |
Remove the brake hose (A) and wheel speed sensor (B).
|
6. |
Remove the tie rod end ball joint(C) from the knuckle.
|
7. |
Remove the lower arm (A) mounting bolt and nut from the knuckle.
|
8. |
Remove the front lower arm from the front knuckle using the SST (0K545-A9100).
|
9. |
Disconnect the drive shaft end (A) from the knuckle. |
10. |
Loosen the strut mounting bolts and then remove the hub and knuckle assembly from the strut assembly (A). |
Tightening torque :
137.2 ~ 156.9N.m (14.0 ~ 16.0kgf.m, 101.2 ~ 115.7Ib-ft) |
Be careful not to damage the boot and rotor teeth. |
1. |
Install in the reverse order of removal.
|
Inspection |
1. |
Check the hub for cracks and the splines for wear. |
2. |
Check the brake disc for scoring and damage. |
3. |
Check the knuckle for cracks |
4. |
Check the bearing for cracks or damage.
|
Disassembly |
1. |
Using the snap ring pliers, remove the snap ring (A). |
2. |
Remove the hub assembly from the knuckle assembly.
|
3. |
Remove the dust cover (A). |
4. |
Remove the hub bearing inner race from the hub assembly
|
5. |
Remove the hub bearing outer race from the knuckle assembly.
|
6. |
Replace hub bearing with a new one. |
Reassembly |
1. |
Install the dust cover (A). |
2. |
Install the hub bearing to the knuckle assembly.
|
3. |
Install the hub assembly to the knuckle assembly.
|
4. |
Install the snap ring (A). |
Voice Recognition
When using the voice recognition feature, only commands listed within the
user's manual are supported.
Be aware that during the operation of the voice recognition system, pressing
any k ...
To defrost outside windshield
1.Set the fan speed to the highest position.
2.Set the temperature to the extreme hot (HI) position.
3.Press the defroster button ().
4.The outside (fresh) air position will be selected automatic ...