If the remaining tread (A) depth is less than the limit, replace the tire.
When the tread depth of the tires is less than 1.6 mm(0.063 in.), the wear indicators (B) will appear.
Tire Rotation
Rotate the tires in the pattern illustrated.
Checking For Pull and Wander
If the steering pulls to one side, rotate the tires according to the following wheel rotation procedure.
1.
Rotate the front right and front left tires, and perform a road test in order to confirm vehicle stability.
2.
If the steering pulls to the opposite side, check vehicle''s
wheel alignment specitication first before fotationg the tires according
to the following wheel rotation procedure.
3.
If the steering continues to pull to one side, rotate the front right and left tires again, and perform a road test.
4.
If the steering continues to pull to the opposite side, replace the front wheels with new ones.
Hub nut tightening sequence
Tighten the hub nuts as follows.
Tightening torque :
88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
When using an impact gun, fi ...
Other Information:
Room lamp
The light will turn on and off as follw if the switch is moved.
• ON : The light stays on at all times.
• OFF : The light stays off at all times.
• DOOR : The light comes on when any door is open ...
SS-A Solenoid Valve(ON/OFF): Specifications
Specifications
ON/OFF Solenoid Valve(SS-A)
? Control type : Normal low type
Control pressure kpa (kgf/cm?, psi)490.33(5.0, 71.12) Internal resistance(?)10 ~ 11
...