Hub nut tightening sequence |
Tightening torque :
88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft) |
When using an impact gun, final tightening torque should be checked using a torque wrench. |
1. |
Jack up the vehicle. |
2. |
Measure the wheel Run-out by using a dial indicator as illustration below.
|
3. |
If measured value exceeds the standard value, replace the wheel. |
Good driving practices
Never move the gear shift lever from P (Park) or N (Neutral) to any other
position with the accelerator pedal depressed.
Never move the gear shift lever into P (Park) when the vehicle is in mo ...
Power Door Mirror Actuator: Repair procedures
Inspection
1.
Disconnect the negative (-) battery terminal.
2.
Remove the front door delta cover.
(Refer to the BD group - "Front door")
3.
Disconnect the connector from the door mirror.
...