Removal |
1. |
Disconnect the battery negative cable and wait for at least thirty seconds before beginning work. |
2. |
Remove the crash pad garnish. (Refer to the Body group- crash pad). |
3. |
Disconnect the passenger airbag connector and remove the PAB mounting bolt. |
4. |
Remove the crash pad. (Refer to the Body group- crash pad).
|
5. |
Remove the heater duct from the crash pad. |
6. |
Remove the mounting nuts(4EA) from the crash pad. Then remove the passenger airbag.
|
Installation |
1. |
Remove the ignition key from the vehicle. |
2. |
Disconnect the battery negative cable from battery and wait for at least thirty seconds before beginning work. |
3. |
Place a passenger airbag on the crash pad and tighten the passenger airbag mounting bolts.
|
4. |
Install the heater duct to the crash pad. |
5. |
Install the crash pad. (Refer to the Body group- crash pad) |
6. |
Tighten the passenger airbag mounting bolt.
|
7. |
Connect the passenger airbag harness connector to the SRS main harness connector. |
8. |
Reinstall the crash pad garnish. (Refer to the Body group- crash pad) |
9. |
Reconnect the battery negative cable. |
10. |
After installing the passenger airbag (PAB), confirm proper system operation:
|
Defroster
CAUTION - Conductors
To prevent damage to the conductors bonded to the inside surface of the rear
window, never use sharp instruments or window cleaners containing abrasives to clean
the wind ...
Engine Control Module (ECM): Repair procedures
Removal
1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.
Disconnect the ECM Connector (A).
3.
Remove the battery (Refer to "Intake And Exhaust System" in EM gr ...