Removal |
1. |
Disconnect the battery negative cable, and wait for at least thirty seconds before beginning work. |
2. |
To remove the seat belt anchor pretensioner (C), keep on
pushing the lock pins (A) as arrow direction. And then remove the seat
belt after pushing the lock pin (B). |
3. |
Remove the following parts. (Refer to the Body group-Interior trim)
|
4. |
Disconnect the anchor pretensioner connector (A). |
5. |
Loosen the anchor pretensioner mounting bolt (B) and remove the anchor pretensioner. |
Installation |
1. |
Remove ignition key from the vehicle. |
2. |
Disconnect the negative (-) cable from battery and wait for at least thirty seconds. |
3. |
Install the anchor pretensioner with a bolt.
|
4. |
Connect the anchor pretensioner connector. |
5. |
Install the following parts. (Refer to the body group - Interior trim)
|
6. |
Insert the seat belt to the anchor pretensioner.
|
7. |
Reconnect the battery negative cable. |
8. |
After installing the anchor pretensioner, confirm proper system operation:
|
Transaxle Control Module (TCM): Repair procedures
Inspection
TCM Problem Inspection Procedure
1.
TEST TCM GROUND CIRCUIT: Measure resistance between TCM and
chassis ground using the backside of TCM harness connector as TCM side
check point. ...
Glove box cooling
You can keep beverage cans or other items cool using the open/close lever of
the vent installed in the glove box.
1.Turn on the air conditioning (A/C) system.
2.Move the open/close lever (1) of ...