Kia Sportage: Front Wheel Speed Sensor: Repair procedures

Removal

Remove the front wheel speed sensor mounting bolt (A).

Tightening torque:

6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)

2.	Remove the front wheel guard .

3.	Disconnect the front wheel speed sensor connector, then remove the front wheel speed sensor.

4.	Installation is the reverse of removal.

Inspection

Measure the output voltage between the terminal of the wheel speed sensor and the body ground.

In order to protect the wheel speed sensor, when measuring output voltage, a 100 ? resistor must be used as shown.

Compare the change of the output voltage of the wheel speed sensor to the normal change of the output voltage as shown below.

V_low : 0.59V ~ 0.84V

V_high : 1.18V ~ 1.68V

Frequency range : 1 ~ 2,500Hz

Components 1. Front wheel speed sensor connector2. Front wheel speed sensor ...

Components 1. Rear wheel speed sensor connector2. Rear wheel speed sensor ...

Overdrive Clutch Control Solenoid Valve(OD/C_VFS): Description and Operation
Description Overdrive clutch control solenoid valve(OD/C) is attached to the valve body. This variable force solenoid valve directly controls the hydraulic pressure inside the overdrive clutch. ...

Injector: Specifications
Specification ItemSpecificationCoil Resistance (?)1.25 [20°C(68°F)] ...

Categories