General |
1. |
Basically, all measurements in this manual are taken with a tracking gauge. |
2. |
When a measuring tape is used, check to be sure there is no elongation, twisting or bending. |
3. |
For measuring dimensions, both projected dimension and actual-measurement dimension are used in this manual. |
Measurement Method |
Projected Dimensions |
1. |
These are the dimensions measured when the measurement
points are projected into the reference plane, and are the reference
dimensions used for body alterations. |
2. |
If the length of the tracking gauge probes is adjustable,
make the measurement by lengthening one probe by the amount equivalent
to the difference in height of the two surfaces. |
Actual-Measurement Dimensions |
1. |
These dimensions indicate the actual linear distance between
measurement points, and are the reference dimensions for use if a
tracking gauge is used for measurement. |
2. |
Measure by first adjusting both probes to the same length (A=A'').
|
Measurement Point |
1. |
Measurements should be taken at the hole center. |
AUX(Auxiliary) Jack: Repair procedures
Removal
1.
Remove the knob. Remove the floor console upper cover (A) using the appropriate tool.
(Refer to the BD group - "Console")
2.
Loosen screws (2EA) and remove the floor console tray ( ...
Speedometer
Type A
Type B
The speedometer indicates the forward speed of the vehicle.
The speedometer is calibrated in kilometers per hour and/or miles per hour. ...