Kia Optima Manuals

Kia Sportage: Front Bumper: Repair procedures - Bumper - Body (Interior and Exterior) - Kia Sportage SL Service & Repair ManualKia Sportage: Front Bumper: Repair procedures

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Body (Interior and Exterior) / Bumper / Front Bumper: Repair procedures

Replacement
   
•
Put on gloves to protect your hands.
•
Use a plastic panel removal tool to remove interior trip pieces to without marring the surface.
•
Take care not bend or scratch the cover and other parts.
1.
Loosen the radiator upper cover (A) mounting clips and bolts.

2.
Remove the under cover (A) mounting clips.

3.
After loosening the front bumper side’s mounting screw, then disconnect the side’s.
   
•
When you pull out the front bumper, the front bumper could be damaged by the projection (A).

4.
Disconnect the fog lamp (A), turn signal lamp (B), front sensor (C).
5.
Remove the front bumper.
[LH]

[RH]

6.
Installation is the reverse of removal.
   
•
Make sure the connector is plugged in properly.
•
Replace any damage clips.
Front Bumper: Components and Components Location
Components 1. Front bumper cover2. Front bumper side bracket [LH]3. Front bumper side bracket [RH] ...

Rear Bumper: Components and Components Location
Components 1. Front bumper cover2. Front bumper side bracket [RH]3. Front bumper side bracket [LH] ...

Other Information:

Repair procedures
Removal 1. Remove the tailgate trim in the trunk after removing the screws and clips. (Refer to the BD group - "Tailgate") 2. Remove the tailgate garnish (A) after disconnecting the connector ...

ESC OFF Switch: Repair procedures
Inspection 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the crash pad side switch assembly. 3. Check the continuity between the switch terminals as ...

Categories


Copyright © www.kispmanual.com 2014-2024