Replacement |
|
1. |
After loosening the mounting screws, then remove the rear combination lamp (A). |
2. |
Push the lock pin, disconnect the connector (B). |
3. |
After loosening the rear bumper side’s mounting screws and clip, then disconnect the side’s. |
4. |
Loosen the mounting bolts. |
5. |
After loosening the mounting screws and clip, then remove the rear bumper (A). |
6. |
Push the lock pin, disconnect the rear bumper main connector (A). |
7. |
Installation is the reverse of removal.
|
Battery Sensor: Description and Operation
Description
Vehicles have many control units that use more electricity.
These units control their own system based on information from diverse
sensors. It is important to have a stable power su ...
Crankshaft Position Sensor (CKPS): Repair procedures
Inspection
1.
Check the signal waveform of the CMPS and CKPS using the GDS.
Specification: Refer to “Wave Form”
Removal
1.
Turn the ignition switch OFF and disconnect the battery negat ...