Kia Optima Manuals

Kia Sportage: Rear Seat Belt: Repair procedures - Seat Belt - Body (Interior and Exterior) - Kia Sportage SL Service & Repair ManualKia Sportage: Rear Seat Belt: Repair procedures

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Body (Interior and Exterior) / Seat Belt / Rear Seat Belt: Repair procedures

Replacement
Rear Seat Belt Replacement
   
•
When installing the belt, make sure not to damaged the retractor.
1.
Remove the following items first.
•
Rear seat assembly
(Refer to the BD group - "Rear Seat")
•
Front door scuff trim & Rear door scuff trim
(Refer to the BD group - "Interior Trim")
2.
Remove the clips and rear transverse trim (A).

3.
After loosening the mounting bolt, then remove the rear seat belt lower anchor (A).
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)

4.
After loosening the mounting bolts, then remove the rear seat mounting bracket (A).

5.
Using a screwdriver or remover, remove the lamp (A).
6.
Disconnect the connector (B).
7.
After loosening the mounting screws, then remove the luggage side trim (C).

8.
Disconnect the connector (A).

9.
After loosening the mounting bolt and screws, then remove the rear pillar trim (A).

10.
After loosening the mounting bolts, then remove the rear seat belt (A).
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)

11.
Installation is the reverse of removal.
   
•
Replace any damaged clips.
•
Make sure the connectors are plugged in properly.
Rear Seat Belt Buckle Replacement
1.
Remove the rear seat.
(Refer to the BD group - "Rear Seat")
2.
After loosening the mounting bolt, then remove the rear seat belt buckle (A).
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)
[LH]

[RH]
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)

3.
Installation is the reverse of removal.
Front Seat Belt: Repair procedures
Replacement Front Seat Belt Replacement     • When installing the belt, make sure not to damaged the pretensioner. 1. Remove the following items first : • ...

Body Electrical System
...

Other Information:

Air cleaner
Filter replacement It must be replaced when necessary, and should not be washed. You can clean the filter when inspecting the air cleaner element. Clean the filter by using compressed air. Repla ...

Purge Control Solenoid Valve (PCSV): Description and Operation
Description Purge Control Solenoid Valve (PCSV) is installed on the surge tank and controls the passage between the canister and the intake manifold. It is a solenoid valve and is open when the ...

Categories


Copyright © www.kispmanual.com 2014-2024