Kia Optima Manuals

Kia Sportage: Thermostat: Repair procedures - Cooling System - Engine Mechanical System - Kia Sportage SL Service & Repair ManualKia Sportage: Thermostat: Repair procedures

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Engine Mechanical System / Cooling System / Thermostat: Repair procedures

Removal and Installation
   
Disassembly of the thermostat would have an adverse effect, causing a lowering of cooling efficiency. Do not remove the thermostat, even if the engine tends to overheat.
1.
Drain engine coolant so its level is below thermostat.
2.
Disconnect the radiator lower hose (A).

3.
Remove water inlet fitting (C), gasket (B) and thermostat (A).
Tightening torque :
7.8 ~ 11.8N.m (0.8 ~ 1.2kgf.m, 5.8 ~ 8.7lb-ft)

4.
Installation is reverse order of removal.
   
•
Install the thermostat with the jiggle valve upward.
•
When assembling the thermostat, place the thermostat on the housing with a protrusion of thermostat matching with a groove of the housing and install the gasket and inlet fitting. Be careful the thermostat doesn’t get out of the groove on the housing.
5.
Fill the engine coolant.
6.
Start the engine and check for leaks.
7.
Recheck the coolant level.
Inspection
1.
Immerse thermostat in water heated to over 95°C (203°F), then heat for at least 3 minutes to check valve lift.

   
•
Do not use water below 95°C (203°F).
•
Do not directly heat unit as this will damage thermostat.
2.
Check the valve opening temperature.
Valve opening temperature: 82 ± 1.5°C (179.6 ± 2.7°F)
Full opening temperature: 95°C (203°F)
If the valve opening temperature is not as specified, replace the thermostat.
3.
Check the valve lift.
Valve lift : 8mm (0.3in.) or more at 95°C (203°F)
If the valve lift is not as specified, replace the thermostat.
Water pump: Troubleshooting
Troubleshooting Water Pump SymptomsPossible CausesRemedyCoolant leakage • From the bleed hole of the water pump Visually check • Check leaks after about ten-minute warming up. ...

Thermostat: Troubleshooting
Troubleshooting SymptomsPossible CausesRemedyCoolant leakage • From the thermostat gasket Check the mounting bolts • Check the torque of the mounting bolts • Retighten ...

Other Information:

Don't let ice and snow accumulate underneath
Under some conditions, snow and ice can build up under the fenders and interfere with the steering. When driving in severe winter conditions where this may happen, you should periodically check un ...

Blower Motor: Repair procedures
Inspection 1. Connect the battery voltage and check the blower motor rotation. 2. If the blower motor is not operating when voltage is applied, substitute with a known-good blower motor and ...

Categories


Copyright © www.kispmanual.com 2014-2024