It will not be configured for any specific platform.
c.
It will not have any sensor ID''s memorized.
1.
Disconnect vehicle battery.
2.
Remove the crash pad garnish.
(Refer to BD group - "Crash Pad")
3.
Remove faulty part and fit bracket assembly to new part.
4.
Secure new part to vehicle and fit connector.
5.
Re-connect battery and turn Ignition on.
6.
After replacing the receiver, learn by using self-diagnosis device(GDS).
Diagnosis procedure by using diagnostic device
As manual for diagnosis methods by using diagnosis device, the main contents are as follows:
1.
Connect self-diagnosis connector(16pins) located in the lower
of driver side crash pad to self-diagnosis device, and then turn the
self-diagnosis device after key is ON.
2.
Select the "vehicle model" and "TPMS" on GDS vehicle selection screen, then select OK.
[Vehicle name input initialization]
[Vehicle name input method 1]
[Vehicle name input method 2]
[Vehicle name input method 3]
[VIN input initialization]
[VIN input method 1]
[VIN input method 2]
[TPMS Mode Configuration]
•
Write ID Read ID and be sure to check are the same.
•
After registering successfully sensor "Sensor Wireless
Information" by the execution determines whether the sensor is working
properly.
Tire specification and pressure label
The tires supplied on your new vehicle are chosen to provide the best performance
for normal driving.
The tire label located on the driver's side center pillar gives the tire pressures
reco ...
Panoramaroof: Components and Components Location
Components
1. Panoramaroof frame assembly2. Movable glass assembly3. Wind deflector assembly4. Mechanism assembly5. Impact bracket6. Impact cross member assembly7. EMC metal sheet8. Motor assembl ...