Inspection |
1. |
Turn ignition switch OFF. |
2. |
Remove the air duct (A). |
3. |
Remove the air cleaner assembly.
|
4. |
Disconnect the solenoid valve connector (A). |
5. |
Measure resistance between sensor signal terminal and ground terminal. |
6. |
Check that the resistance is within the specification. |
Removal |
1. |
Change the shift lever to "N" range. |
2. |
Remove the valve body assembly.
(Refer to "Valve Body" in Hydraulic System) |
3. |
Disconnect the input & output speed sensor connector (A). |
4. |
Loosen the main connctor bolt (B).
|
5. |
Dissconnect the solenoid valve connector (A). |
6. |
Remove the solenoid valve connector clip (B) after loosening a bolt and then remove the connector by pushing down to it. |
Installation |
1. |
Install in the reverse order of removal.
|
Jack and tools
The jack, jack handle, wheel lug nut wrench are stored in the luggage compartment.
Pull up the luggage box cover to reach this equipment.
(1) Jack handle
(2) Jack
(3) Wheel lug nut wrench
Jacki ...
Camshaft Position Sensor (CMPS): Repair procedures
Inspection
1.
Check the signal waveform of the CMPS and CKPS using the GDS.
Specification: Refer to “Wave Form”
Removal
•
DON’T remove the camshaft ...