Kia Sportage: Turbo Charger: Components and Components Location - Intake And Exhaust System - Engine Mechanical System - Kia Sportage SL Service & Repair ManualKia Sportage: Turbo Charger: Components and Components Location

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Engine Mechanical System / Intake And Exhaust System / Turbo Charger: Components and Components Location

Components

1. Turbine housing
2. Turbine inlet
3. Turbine outlet
4. Compressor housing
5. Compressor inlet
6. Compressor outlet
7. Center housing
8. EWGA (Electric Waste Gate Actuator)
9. Actuator rod

Exhaust Manifold: Repair procedures
Removal and Installation 1. Remove the engine cover. 2. Disconnect the battery negative terminal (A). Tightening torque 4.0 ~ 6.0N.m (0.4 ~ 0.6kgf.m, 3.0 ~ 4.4lb-ft) 3. Disconnect t ...

Turbo Charger: Repair procedures
On-vehicle Inspection Turbocharger Diagnostic Flow If any problem related with turbocharger, such as lack of engine power, poor acceleration, abnormal engine noise or oil leaks, may occur, c ...

Other Information:

Do not lie down
To reduce the chance of injuries in the event of an accident and to achieve maximum effectiveness of the restraint system, all passengers should be sitting up and the front and rear seats should b ...

3 Point rear center belt
To fasten the rear center belt 1.Extract the tongue plate from the hole on the belt assembly cover and slowly pull the tongue plates out from the retractor. 2.Insert the tongue plate (A) into ...

Categories


Copyright © www.kispmanual.com 2014-2024