Removal |
1. |
Lift up the vehicle.
(Refer to GI group - "Lift and support points") |
2. |
Remove the rear bumper.
(Refer to the BD group - "Rear bumper") |
3. |
Pull out the sensor by opening the sensor holder out. |
4. |
Disconnect the connector from the ultrasonic sensor. |
Installation |
1. |
Install the sensor and connector. |
Economical operation
Your vehicle's fuel economy depends mainly on your style of driving, where you
drive and when you drive.
Each of these factors affects how many kilometers (miles) you can get from a
liter (ga ...
Heater & A/C Control Unit(Manual): Components and Components Location
Components
Connector Pin Function
ConnectorPin NoFunctionConnectorPin NOFunctionConnector(A)1HighConnector(B)1Tail Lamp (ILL+)2Middle High2Battery3Middle Low3Mode Actuator (VENT)4-4Mode Actuator ...