Inspection |
1. |
Turn ignition switch OFF. |
2. |
Remove the air duct (A). |
3. |
Remove the air cleaner assembly.
|
4. |
Disconnect the solenoid valve connector (A). |
5. |
Measure resistance between sensor signal terminal and ground terminal. |
6. |
Check that the resistance is within the specification. |
Removal |
Replacing an on/off solenoid valve (SS-A, SS-B) does not
require additional hydraulic pressure adjustment; however, the hydraulic
pressure will need to be adjusted after replacing the VFS solenoid
valve. If replacing the VFS solenoid valve; also replace the valve body
assembly.
(Refer to "Valve Body" in Hydraulic System of this group) |
Voice Recognition
When using the voice recognition feature, only commands listed within the
user's manual are supported.
Be aware that during the operation of the voice recognition system, pressing
any k ...
Front seat heater
Type A
The seat heater is provided to warm the front seats during cold weather. With
the ignition switch in the ON position, push either of the switches to warm the
driver's seat or the fro ...