Kia Sportage: Water pump: Components and Components Location - Cooling System - Engine Mechanical System - Kia Sportage SL Service & Repair ManualKia Sportage: Water pump: Components and Components Location

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Engine Mechanical System / Cooling System / Water pump: Components and Components Location

Components

1. Water pump pulley
2. Water pump sub assembly
3. Water pump gasket
4. Water pump cover
5. Water pump cover gasket
6. O-ring
7. Water inlet pipe
8. Water temperature control assembly
9. Water inlet fitting
10. Engine coolant temperature sensor
11. Thermostat
12. Thermostat gasket
13. Throttle body coolant hoses
14. Oil cooler coolant hoses

Radiator: Repair procedures
Inspection Radiator Cap Testing 1. Remove the radiator cap, wet its seal with engine coolant, and then install it on a pressure tester. 2. Apply a pressure of 93.16 ~ 122.58kPa (0.95 ~ 1.25kg ...

Water pump: Repair procedures
Removal and Installation 1. Loosen the drain plug, and then drain the engine coolant. Remove the radiator cap to drain with speed. 2. Remove the drive belt (A) after turning the drive belt ten ...

Other Information:

Torque Converter Control Solenoid Valve (T/CON_VFS): Schematic Diagrams
Circuit Diagram ...

2. Evaporative emission control (including ORVR: Onboard Refueling Vapor Recovery) system
The Evaporative Emission Control System is designed to prevent fuel vapors from escaping into the atmosphere. (The ORVR system is designed to allow the vapors from the fuel tank to be loaded into ...

Categories


Copyright © www.kispmanual.com 2014-2024