Remove the steering column upper and lower shrouds (A) after removing 3 screws.
Take care not to damage and scratch the shrouds and its related parts.
Take care not to damage the hook when removing the upper and lower shrouds.
3.
Disconnect the light switch connector (A) and the wiper switch connector (B).
4.
Remove the wiper switch (A) by pushing the lock pin (B).
When removing the wiper & washer switch only, release the lock of wiper switch without removing the steering wheel.
5.
Remove the steering wheel.
(Refer to ST group - "Steering column and shaft")
6.
Remove the clock spring.
(Refer to RT group - "Airbag module")
7.
Remove the multifunction switch assembly (A) after loosening screws (2EA).
Installation
1.
Install the multifunction switch after connecting the connector.
2.
Install the clock spring and steering wheel.
3.
Install the steering column upper and lower shrouds.
Inspection
Check for continuity between the terminals while operating
the wiper and washer switch. If it is not normal condition, replace
wiper and washer switch.
Component Location
1. Cap2. Nut3. Wiper arm & blade4. Clip5. Cowl top cover6. Bolt7. Wiper motor & linkage assembly8. Wiper motor connector
...
Other Information:
Digital clock
Whenever the battery terminals or related fuses are disconnected, you must reset
the time.
For details, refer to the audio in the end of this section.
WARNING - Clock those may damage the ho ...
Repair procedures
Replacement
Problems And Replacement Parts:
ProblemPart setScan tool required?All keys have been lostBlank key (4)YESAntenna coil unit does not workAntenna coil unitNOECM does not workPCM(ECM)YE ...