Kia Sportage: Airbag inflation conditionsThe air bags fitted to your vehicle may differ from those shown in the illustrations.
|
Air bag inflation conditions |
|
|---|---|
|
Front air bags are designed to inflate in a frontal collision when warranted by the impact's severity, speed and direction. |
|
Side and/or curtain air bags are designed to inflate when side-impact sensors detect a collision that meets the deployment criteria. Their response depends on factors including the impact's strength, speed and direction. |
NOTE
Side and curtain air bags
On vehicles equipped with a rollover sensor, the side and curtain air bags are designed to inflate when the sensor detects a rollover.
Front air bags are designed primarily for frontal collisions, but may also inflate in another type of collision if the front impact sensors detect a sufficiently strong impact. Side air bags, including curtain air bags, are designed primarily for side impacts, but may also inflate in another collision if the side impact sensors detect a sufficiently strong impact.
For example, side or curtain air bags may deploy if the rollover sensors detect a possible rollover, even if the vehicle does not actually roll over. They may also deploy in other situations, such as when the vehicle is tilted during towing. In a rollover, side and curtain air bags may deploy to help prevent occupants from being ejected, particularly occupants who are wearing seat belts, even though these air bags do not provide impact protection in that situation.
Impacts to the vehicle chassis from bumps or objects on rough roads or pavements may also cause air bags to deploy. Drive carefully on unpaved roads and surfaces not intended for vehicle traffic to help prevent unintended deployment.
NOTE
If equipped with a rollover sensor
The side and curtain air bags are also designed to inflate when a rollover is detected by the rollover sensor.
Blower Unit: Repair procedures
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad and heater blower unit.
(Refer to HA group - "Heater Unit")
3.
Remove the heater blower unit (A) fro ...
Repair procedures
Inspection
[System Inspection]
1.
Disconnect the vapor hose from the intake manifold and connect a vacuum pump to the nipple on the intake manifold.
· At Cold Engine [Engine Coolant Temperatu ...
Map lamp
The light will turn on and off as below if the switch is pressed. The light will
turn off if the button is pressed again.
• Push the lens to turn the map lamp on or off. This light produces a s ...