Kia Sportage: Brake/clutch fluid. Checking brake/clutch fluid level. Washer fluid. Checking washer fluid level - MaintenanceKia Sportage: Brake/clutch fluid. Checking brake/clutch fluid level. Washer fluid. Checking washer fluid level

Kia Sportage Owner’s Manual (5th Generation, NQ5; 2022+) / Maintenance / Brake/clutch fluid. Checking brake/clutch fluid level. Washer fluid. Checking washer fluid level

Brake/clutch fluid. Checking brake/clutch fluid level

Checking brake/clutch fluid level

Kia Sportage brake and clutch fluid reservoir location

Procedure

  1. Clean the area around the reservoir cap before opening it, so dirt cannot enter the fluid system.

  2. Check the fluid level in the brake fluid reservoir regularly. It should remain between the MIN and MAX marks. The level may gradually fall as the vehicle accumulates mileage; this is normally associated with wear of the brake linings.

Continue to check the reservoir periodically and do not allow the level to fall below MIN or rise above MAX. Never mix different types of fluid.

Use only the specified brake or clutch fluid. Refer to the “Brake/clutch fluid” section for the applicable specification.

Caution

To maintain the Kia Sportage braking system and ABS/ESC performance, use genuine Kia brake fluid or fluid that meets the equivalent specification.

Tip

If the fluid level is unusually low, have the system inspected by a professional workshop. Kia recommends visiting an authorised Kia dealer or service partner.

Washer fluid. Checking washer fluid level

Checking washer fluid level

Kia Sportage windscreen washer fluid reservoir location

Procedure

The reservoir is translucent, allowing you to check its fluid level with a quick visual inspection.

Warning

Engine coolant
Checking coolant level Inspect the cooling system and heater hoses, including their connections. Replace any hose that is swollen, worn or ...
Parking brake. Checking the parking brake (hand type, if equipped). Fuel filter (diesel)
Parking brake. Checking the parking brake (hand type, if equipped) Checking the parking brake (hand type, if equipped) Check the parking brake stroke by counting the...
See also:

Front Wiper Motor: Components and Components Location
Component Location 1. Cap2. Nut3. Wiper arm & blade4. Clip5. Cowl top cover6. Bolt7. Wiper motor & linkage assembly8. Wiper motor connector ...

To turn off the blowers
To turn off the blowers, turn the fan speed control knob to the "0" position. ...

Canister Close Valve (CCV): Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the CCV connector. 3. Measure resistance between the CCV terminal 1 and 2. 4. Check that the resistance is within the specific ...

Categories

Copyright © www.kispmanual.com 2014-2026 - 0.084