Kia Sportage: Rear Cross-Traffic Collision-Avoidance Assist Settings - Rear Cross-Traffic Collision-Avoidance Assist (RCCA): If Equipped - Driver assistance systemKia Sportage: Rear Cross-Traffic Collision-Avoidance Assist Settings

Kia Sportage Owner’s Manual (5th Generation, NQ5; 2022+) / Driver assistance system / Rear Cross-Traffic Collision-Avoidance Assist (RCCA): If Equipped / Rear Cross-Traffic Collision-Avoidance Assist Settings

Rear Cross-Traffic Safety

Kia Sportage infotainment settings path to Rear Cross-Traffic Safety
  1. Driver Assistance
  2. Parking Safety
  3. Rear Cross-Traffic Safety

With the Kia Sportage switched on, open the infotainment system settings and select Setup > Vehicle > Driver Assistance > Parking Safety > Rear Cross-Traffic Safety to switch Rear Cross-Traffic Collision-Avoidance Assist on or off.

WARNING

Rear Cross-Traffic Collision-Avoidance Assist is switched on whenever the vehicle is restarted. If you turn off Rear Cross-Traffic Safety after restarting the Kia Sportage, remain alert to the surrounding area and manoeuvre carefully.

Warning Method

Kia Sportage infotainment settings showing Driver Assistance and Warning Method
  1. Driver Assistance
  2. Warning Method

Set the Warning Method while the Kia Sportage is switched on. In the infotainment system settings, select Setup > Vehicle > Driver Assistance > Warning Method to adjust the following options:

TIP

Rear Cross-Traffic Collision-Avoidance Assist (RCCA): If Equipped
When the Kia Sportage is reversing, Rear Cross-Traffic Collision-Avoidance Assist detects vehicles approaching from the left or right behind the vehicle. If the system identifies a possible collisi...
Rear Cross-Traffic Collision-Avoidance Assist Operation
Rear Cross-Traffic Collision-Avoidance Assist responds according to the level of collision risk. Its operation may include the following stages: Collision warning Emergency braking Bring...
See also:

4WD LOCK indicator
The 4WD LOCK indicator light is illuminated when the 4WD LOCK button is pushed. The purpose of this 4WD LOCK mode is to increase the drive power when driving on wet pavement, snow-covered roads ...

Repair procedures
On-vehicle Inspection Spark Test 1. Disconnect the ignition coil connectors (A). 2. Remove the ignition coils (A). 3. Using a spark plug socket, remove the spark plug. 4. Install th ...

Certification label
The certification label is located on the driver's door sill at the center pillar. This label shows the maximum allowable weight of the fully loaded vehicle. This is called the GVWR (Gross Vehi ...

Categories

Copyright © www.kispmanual.com 2014-2026 - 0.0684