Kia Sportage: 26 Brake Control Solenoid Valve(26/B_VFS): Repair procedures| Inspection |
| 1. |
Turn ignition switch OFF. |
| 2. |
Remove the air duct (A).
|
| 3. |
Remove the air cleaner assembly.
|
| 4. |
Disconnect the solenoid valve connector (A).
|
| 5. |
Measure resistance between sensor signal terminal and ground terminal. |
| 6. |
Check that the resistance is within the specification. |
| Removal |
Replacing an on/off solenoid valve (SS-A, SS-B) does not
require additional hydraulic pressure adjustment; however, the hydraulic
pressure will need to be adjusted after replacing the VFS solenoid
valve. If replacing the VFS solenoid valve; also replace the valve body
assembly.
(Refer to "Valve Body" in Hydraulic System of this group) |
26 Brake Control Solenoid Valve(26/B_VFS): Schematic Diagrams
Line Pressure Control Solenoid Valve: Description and OperationFront Driveshaft: Repair procedures
Replacement
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the front wheel and tire (A) from front hub.
Tightening torque :
88.3 ~ ...
Oil Pump: Components and Components Location
Component Location
1. Automatic transaxle2. Oil pump assembly
Component
1. Reaction shaft support assembly2. Oil pump housing3. Driven gear4. Drive gear5. Oil seal6. Bush-Housing7. Reactio ...