Inspection |
1. |
Turn ignition switch OFF. |
2. |
Remove the air duct (A). |
3. |
Remove the air cleaner assembly.
|
4. |
Disconnect the solenoid valve connector (A). |
5. |
Measure resistance between sensor signal terminal and ground terminal. |
6. |
Check that the resistance is within the specification. |
Removal |
Replacing an on/off solenoid valve (SS-A, SS-B) does not
require additional hydraulic pressure adjustment; however, the hydraulic
pressure will need to be adjusted after replacing the VFS solenoid
valve. If replacing the VFS solenoid valve; also replace the valve body
assembly.
(Refer to "Valve Body" in Hydraulic System of this group) |
Troubleshooting
Troubleshooting
SymptionSuspect areaRemedyEngine misfire with abnormal internal lower engine noises.Worn crankshaft bearingsLoose or out of specification engine flywheelReplace the crankshaft and ...
Components and Components Location
Component Location
1. Rear glass defogger relay2. Rear glass defogger switch3. Rear glass defogger
...