Inspection |
1. |
Ignition "OFF" |
2. |
Disconnect ambient temperature sensor. |
3. |
Check the resistance of ambient temperature sensor between
terminals 1 and 2 whether it is changed by changing of the ambient
temperature.
Specification
|
4. |
If the measured resistance is not specification, substitute
with a known-good ambient temperature sensor and check for proper
operation. |
5. |
If the problem is corrected, replace the ambient temperature sensor. |
Replacement |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Disconnect the connector and then remove the ambient temperature sensor (A). |
3. |
Installation is the reverse order of removal. |
Jack and tools
The jack, jack handle, wheel lug nut wrench are stored in the luggage compartment.
Pull up the luggage box cover to reach this equipment.
(1) Jack handle
(2) Jack
(3) Wheel lug nut wrench
Jacki ...
Heater & A/C Control Unit(Manual): Repair procedures
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Using the screwdriver, remove the cluster facia panel (A).
3.
Using the screwdriver, remove the crash pad garnish (A).
4. ...