Kia Sportage: Distributing the Sealant. Checking Tyre Inflation Pressure

Distributing the Sealant

Procedure

• Drive immediately for approximately 7–10 km (4–6 miles), or about 10 minutes, to spread the sealant evenly inside the tyre.

WARNING

• Do not leave the Kia Sportage running for a long time in a poorly ventilated area. Exhaust gases contain carbon monoxide, which can cause poisoning or suffocation.
• If tyre pressure is below 26 psi (180 kPa), do not drive the vehicle. Driving in this condition may cause an accident.

CAUTION

• Secure the sealant filling hose firmly to the tyre valve. If it is not properly attached, sealant may flow backwards and clog the hose.
• Do not exceed 80 km/h (50 mph). If possible, maintain a speed of at least 20 km/h (12 mph). If you notice unusual vibration, a change in ride quality, or unexpected noise, slow down and continue cautiously only until you can safely leave the road. Call roadside assistance or arrange towing. Sealant may stain the wheel; have the stained wheel and vehicle inspected by a qualified workshop. Kia recommends visiting an authorised Kia dealer or service partner.
• Do not connect a Tyre Mobility Kit from another vehicle to the Kia Sportage power outlet or battery terminal. A difference between the vehicle’s power supply and the kit’s requirements may cause a fire or damage the vehicle’s electrical circuit or the kit.

Checking Tyre Inflation Pressure

Procedure

• After driving approximately 7–10 km (4–6 miles), or about 10 minutes, stop the Kia Sportage in a safe, level place.

• Connect the filling hose directly to the tyre valve.

• Plug in the power connector.

• Adjust the tyre pressure to the specified value.

  • To increase pressure, switch on the compressor. Switch it off briefly to check the current pressure.
  • To reduce pressure, turn the compressor valve.

WARNING

• Do not run the compressor for more than 10 minutes. Longer operation may cause it to overheat and become damaged.
• Inflate the tyre to the correct pressure specified in “Tyres and Wheels.” If the proper pressure cannot be reached, do not continue driving. Call roadside assistance or arrange towing.

CAUTION

• If the tyre does not maintain pressure, drive the vehicle again as described in “Distributing the Sealant,” then repeat the pressure-checking procedure from the first step.
• The Tyre Mobility Kit may not be effective for tyre damage larger than approximately 4 mm (0.16 in.).
• If the kit cannot make the tyre safe for road use, contact a qualified workshop.

NOTE

When refitting the repaired or replacement tyre and wheel to the Kia Sportage, tighten the wheel lug nuts to 11–13 kgf·m (79–94 lbf·ft).

Components of the Tyre Mobility Kit. Using the Tyre Mobility Kit

Components of the Tyre Mobility Kit The connectors, power cable, and connection hose are stored in the compressor housing. Follow the specified connection sequence carefully. If the steps are perfo...

Safe Use of the Tyre Mobility Kit

Stop the Kia Sportage in a safe, level place away from traffic. Apply the parking brake. Use the Tyre Mobility Kit only to seal and inflate passenger-car tyres. Do not remove foreign objects ...