Kia Sportage: Electronic Parking Brake (EPB): (if equipped)

Applying the EPB manually

Operation

• Press the brake pedal, then pull the EPB switch up to apply the parking brake.

• To release the parking brake, press the brake pedal, make sure the gear is in P (Park), and push the EPB switch down.

WARNING

• Children left unattended in the vehicle could accidentally set it in motion and risk serious injury. They may be able to:

  • Release the parking brake.

  • Shift the transmission out of P (Park).

  • Start the engine or operate vehicle equipment.

• Never leave children or animals unattended in the Kia Sportage.

• When leaving the vehicle, take the smart key with you and lock the doors.

NOTE

• If the vehicle does not remain stationary on a steep slope or while towing a trailer, take these steps:

  • Apply the EPB.

  • Pull the EPB switch up and hold it for more than three seconds.

• You may hear a click or the electric brake motor while applying or releasing the EPB. These sounds are normal and indicate that the system is operating.

Applying the EPB automatically

Operating conditions

• On models with a shift dial SBW system, the EPB applies when P (Park) is selected on a slope.

• The vehicle is switched to OFF while AUTO HOLD is active.

• On models with a shift dial SBW system, the vehicle moves slightly while in P (Park).

• Another vehicle system requests EPB application.

• While AUTO HOLD is active, the EPB may apply automatically in any of these situations:

  • The driver’s door is opened.

  • The bonnet is opened.

  • The tailgate is opened.

  • The vehicle remains stopped for more than approximately 10 minutes.

  • The vehicle is stopped on a steep slope.

  • Another system requests EPB application.

NOTE

On Kia Sportage models equipped with both EPB and AUTO HOLD, the EPB applies automatically if the ENGINE START/STOP button is switched to OFF while AUTO HOLD is active. Turn off AUTO HOLD before switching off the vehicle.

Releasing the EPB automatically

Operation

• Gear in P (Park)

With the engine running, press the brake pedal and shift from P (Park) to R (Reverse) or D (Drive).

• Gear in N (Neutral)

With the engine running, press the brake pedal and shift from N (Neutral) to R (Reverse) or D (Drive).

Operating conditions

1. Make sure the seat belts are fastened and the doors, bonnet and tailgate are closed.

2. With the engine running and the brake pedal pressed, shift from P (Park) to R (Reverse), D (Drive) or Manual shift mode.

3. Press the accelerator pedal.

4. Check that the parking brake warning light has gone out before driving.

CAUTION

Do not drive the Kia Sportage with the EPB applied. Doing so may cause excessive wear to the brake pads and discs.

NOTE

• Do not use the following procedures on a flat, level surface, as the vehicle may move forward unexpectedly:

  • For safety, press the brake pedal and release the parking brake manually with the EPB switch when driving downhill or reversing.

  • You can apply the EPB while the vehicle is in the OFF position, but you cannot release it in that position.

• If the parking brake warning light remains on after the EPB has been released, have the system inspected by a professional workshop. Kia recommends contacting an authorised Kia dealer or service partner.

EPB warning messages

Operating conditions

• You attempt to drive away by pressing the accelerator while the EPB is applied.

• The driver’s seat belt is unfastened, or the bonnet, driver’s door or tailgate is open.

• A vehicle system fault is detected.

• The system cannot complete the transition from AUTO HOLD to the EPB correctly.

• The EPB applies in response to an Electronic Stability Control (ESC) signal while AUTO HOLD is active.

EPB malfunction indicator

The EPB may have a fault if its malfunction indicator stays on, illuminates while driving, or fails to illuminate when the vehicle is in the ON position.

Arrange an inspection as soon as possible at a professional workshop. Kia recommends contacting an authorised Kia dealer or service partner.

NOTE

• The EPB warning light may illuminate if the EPB switch is operated abnormally. Switch off the engine and restart it after a few minutes. The warning light may then go out and the switch may operate normally. If the warning light remains on, have the system inspected by a professional workshop. Kia recommends contacting an authorised Kia dealer or service partner.

• If the parking brake warning light does not illuminate, or blinks when you pull up the EPB switch, the EPB has not been applied.

• If the parking brake warning light blinks while the EPB warning light is on, press the EPB switch down and then pull it up. Return the switch to its original position once more, then pull it up again. If the EPB warning remains on, have the system inspected by a professional workshop. Kia recommends contacting an authorised Kia dealer or service partner.

Emergency braking with the EPB switch

To apply the emergency brake, pull the EPB switch up and hold it.

WARNING

Do not operate the Electronic Parking Brake (EPB) while the Kia Sportage is moving unless there is an emergency. Applying the EPB at normal driving speeds can cause a sudden loss of control. If you must use it to stop the vehicle, apply it with great caution.

NOTE

During emergency braking with the EPB, the parking brake warning light illuminates to show that the system is operating.

If the EPB does not release correctly

Transport the vehicle on a flatbed tow truck to a professional workshop for inspection. Kia recommends contacting an authorised Kia dealer or service partner.

Parking brake (hand-operated type): (if equipped)

After parking the Kia Sportage, apply the parking brake to help prevent the vehicle from moving under external force. Applying the parking brake ...

AUTO HOLD: (if equipped)

AUTO HOLD keeps the Kia Sportage stationary after you stop without requiring you to keep your foot on the brake pedal. Applying AUTO HOLD Operation Press the AUTO HOLD button. Its indica...