Kia Sportage: Filler-Neck Assembly: Repair procedures
Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Engine Control / Fuel System / Fuel Delivery System / Filler-Neck Assembly: Repair procedures
| Removal |
| 1. |
Remove the rear-LH wheel, tire, and the inner wheel house. |
| 2. |
Disconnect the fuel filler hose (A) and the ventilation hose (B).
|
| 3. |
Open the fuel filler door and unfasten the filler-neck assembly mounting screw (A).
|
| 4. |
Remove the filler-neck assembly from the vehicle after removing the bracket mounting nut (A).
|
| Installation |
| 1. |
Installation is reverse of removal.
|
Fuel Pump: Repair procedures
Inspection
[Fuel pump]
1.
Turn the ignition switch OFF, and then remove battery (-) cable.
2.
Remove the fuel pump assembly.
3.
Check motor operation by fuel pump connector (A) connecti ...
Accelerator Pedal: Repair procedures
Removal
1.
Turn the ignition switch OFF and disconnect the negative (-) battery cable.
2.
Disconnect the accelerator position sensor connector (A).
3.
Remove the installation nuts (B), th ...
Other Information:
ESC (Electronic Stability Control) indicator
The ESC indicator will illuminate when the ignition switch is turned ON, but
should go off after approximately 3 seconds. When the ESC is on, it monitors the
driving conditions and under normal ...
TPMS Sensor: Description and Operation
Description
1.
Mode
(1)
Normal Fixed Base State
•
Sensor transmissions continue at the Low Line (Base)
configuration defined rates until the state is either changed by LF
command o ...
Categories
- Home
- Kia Sportage QL (2015-2019) Owners Manual
- Kia Sportage QL (2015-2019) Service Manual
- Kia Sportage SL 2010-2016 Owners Manual
- Kia Sportage SL 2010-2016 Service Manual
Copyright www.kispmanual.com 2014-2026