Kia Sportage: Front Impact Sensor (FIS): Description and Operation
Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Restraint / SRSCM / Front Impact Sensor (FIS): Description and Operation
| Description |
The front impact sensor (FIS) is installed in the Front End
Module (FEM). They are remote sensors that detect acceleration due to a
collision at its mounting location. The primary purpose of the Front
Impact Sensor (FIS) is to provide an indication of a collision. The
Front Impact Sensor (FIS) sends acceleration data to the SRSCM.
SRS Control Module (SRSCM): Repair procedures
Removal
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three minutes before beginning work.
3.
Disconnect the DAB, PAB, SAB, CA ...
Other Information:
Rear Hub - Carrier: Repair procedures
Replacement
1.
Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported.
2.
Remove the rear wheel and tire (A) from rear hub.
Tightening torque :
88.3 ~ 1 ...
Fuel Pressure Control Valve: Description and Operation
Description
Fuel Pressure Regulator Valve is installed on the high
pressure fuel pump and controls fuel flow flowing into the injectors in
accordance with the ECM signal calculated based on var ...
Categories
- Home
- Kia Sportage QL (2015-2019) Owners Manual
- Kia Sportage QL (2015-2019) Service Manual
- Kia Sportage SL 2010-2016 Owners Manual
- Kia Sportage SL 2010-2016 Service Manual
Copyright www.kispmanual.com 2014-2026