Kia Optima Manuals

Kia Sportage: Muffler: Repair procedures - Intake And Exhaust System - Engine Mechanical System - Kia Sportage SL Service & Repair ManualKia Sportage: Muffler: Repair procedures

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Engine Mechanical System / Intake And Exhaust System / Muffler: Repair procedures

Removal and Installation
1.
Remove the front muffler (A).
Tightening torque:
39.2 ~ 58.8 N.m (4.0 ~ 6.0 kgf.m, 28.9 ~ 43.4 lb-ft)

2.
Remove the catalytic converter (B) after removing the rear oxygen sensor (A).
Tightening torque:
Oxygen sensor (A): 44.1 ~ 49.0 N.m (4.5 ~ 5.0 kgf.m, 32.5 ~ 36.2 lb-ft)
Nuts (B): 39.2 ~ 58.8 N.m (4.0 ~ 6.0 kgf.m, 28.9 ~ 43.4 lb-ft)

3.
Remove the center muffler (A).
Tightening torque:
39.2 ~ 58.8 N.m (4.0 ~ 6.0 kgf.m, 28.9 ~ 43.4 lb-ft)

4.
Remove the main muffler (A).

5.
Installation is the reverse order of removal.
   
When installing, replace with new gaskets.
Muffler: Components and Components Location
Components 1. Front muffler2. Catalytic converter3. Center muffler4. Main muffler5. Gasket ...

Engine Electrical System
...

Other Information:

Cylinder Block: Components and Components Location
Components 1. Piston ring2. Snap ring3. Piston4. Connecting rod 5. Connecting rod upper bearing6. Piston pin7. Connecting rod lower bearing8. Connecting rod bearing cap9. Ladder frame10. Oil filt ...

Camshaft Position Sensor (CMPS): Repair procedures
Inspection 1. Check the signal waveform of the CMPS and CKPS using the GDS. Specification: Refer to “Wave Form” Removal     • DON’T remove the camshaft ...

Categories


Copyright © www.kispmanual.com 2014-2025