Kia Sportage: Propeller Shaft Assembly - Driveshaft and axle - Kia Sportage SL Service & Repair ManualKia Sportage: Propeller Shaft Assembly

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Driveshaft and axle / Propeller Shaft Assembly

Rear Driveshaft: Repair procedures
Replacement 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the rear wheel and tire (A) from rear hub. Tightening torque : 88.3 ~ 1 ...

Propeller Shaft: Components and Components Location
Components 1. Front propeller shaft2. Center bearing bracket3. Rear propeller shaft ...

Other Information:

Yaw-rate and Lateral G Sensor: Repair procedures
Removal 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the floor console upper cover. 3. Disconnect the yaw rate & lateral & Longitudinal G se ...

TPMS Sensor: Description and Operation
Description 1. Mode (1) Normal Fixed Base State • Sensor transmissions continue at the Low Line (Base) configuration defined rates until the state is either changed by LF command or ...

Categories


Copyright © www.kispmanual.com 2014-2025