Kia Optima Manuals

Kia Sportage: Rear Bumper: Repair procedures - Bumper - Body (Interior and Exterior) - Kia Sportage SL Service & Repair ManualKia Sportage: Rear Bumper: Repair procedures

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Body (Interior and Exterior) / Bumper / Rear Bumper: Repair procedures

Replacement
   
•
Put on gloves to protect your hands.
•
Use a plastic panel removal tool to remove interior trip pieces to without marring the surface.
•
Take care not bend or scratch the cover and other parts.
1.
After loosening the mounting screws, then remove the rear combination lamp (A).
2.
Push the lock pin, disconnect the connector (B).

3.
After loosening the rear bumper side’s mounting screws and clip, then disconnect the side’s.

4.
Loosen the mounting bolts.

5.
After loosening the mounting screws and clip, then remove the rear bumper (A).

6.
Push the lock pin, disconnect the rear bumper main connector (A).

7.
Installation is the reverse of removal.
   
•
Make sure the connector is plugged in properly.
•
Replace any damage clips.
Rear Bumper: Components and Components Location
Components 1. Front bumper cover2. Front bumper side bracket [RH]3. Front bumper side bracket [LH] ...

Seat & Power Seat
...

Other Information:

Starter Relay: Repair procedures
Inspection 1. Remove the fuse box cover. 2. Remove the starter relay (A). 3. Using an ohmmeter, check that there is continuity between each terminal. TerminalContinuity30 - 87NO85 - 86Y ...

Mode Control Actuator: Components and Components Location
Component Location ...

Categories

Copyright www.kispmanual.com 2014-2026