The rear window wiper and washer switch is located at the end of the wiper and washer switch lever. Turn the switch to the desired position to operate the rear wiper and washer.
ON - Normal wiper operation
INT - Intermittent wiper operation (if equipped)
OFF - Wiper is not in operation
Push the lever away from you to spray rear washer fluid and to run the rear wipers 1~3 cycles. The spray and wiper operation will continue until you release the lever.
Oil Cooler: Repair procedures
Removal
1.
Loosen the drain plug, and drain the coolant. Remove the radiator cap to speed draining.
2.
Disconnect the oil cooler coolant hoses (A).
3.
Remove the oil filter (A).
4.
Loo ...
Forward and backward
Push the control switch forward or backward to move the seat to the desired position.
Release the switch once the seat reaches the desired position. ...