Kia Optima Manuals

Kia Sportage: Repair procedures - Automatic Transaxle Control System - Automatic Transaxle System - Kia Sportage SL Service & Repair ManualKia Sportage: Repair procedures

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Automatic Transaxle System / Automatic Transaxle Control System / Repair procedures

Adjustment
TCM Learning
When shift shock is occurred or parts related with the transaxle are replaced, TCM learning should be performed.
In the following case, TCM learning is required.
•
Transaxle assembly replacement
•
TCM replacement
•
TCM upgrading
1.
TCM learning condition
–
ATF temperature: 60~115°C (140~239°F)
2.
TCM learning procedure
A.
Stop learning
Repeat the below shift pattern four times or more with stepping on the brake.

B.
Driving learning
1)
Drive the vehicle through all gears at D range. Drive from stop to 1st to 2nd to 3rd to 4th to 5th to 6th with keeping fixed throttle open.
2)
Down shift from 6th to 5th, 5th to 4th, 4th to 3rd, 3rd to 2nd, 2nd to 1st.
3)
Repeat the above driving pattern four times or more.
Up-shift throttle open : 15~30%
Description and Operation
Description Automatic transaxle system relies on various measurement data to determine the current control status and extrapolate the necessary compensation values. These values are used to con ...

Schematic Diagrams
Circuit Diagram ...

Other Information:

Front Door: Components and Components Location
Components 1. Front door trim2. Front door inside handle cap3. Front door trim seal4. Front door quadrant inner cover5. Front door module6. Front door panel7. Front door belt outside moulding8. ...

Intake Air Temperature Sensor (IATS): Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the IATS connector. 3. Measure resistance between the IATS terminals 3 and 4. 4. Check that the resistance is within the speci ...

Categories

Copyright www.kispmanual.com 2014-2026