Kia Sportage: Safe Exit Warning malfunction and limitations - Safe Exit Warning (SEW): (if equipped) - Driver assistance systemKia Sportage: Safe Exit Warning malfunction and limitations

Kia Sportage Owner’s Manual (5th Generation, NQ5; 2022+) / Driver assistance system / Safe Exit Warning (SEW): (if equipped) / Safe Exit Warning malfunction and limitations

Safe Exit Warning malfunction

Kia Sportage instrument cluster message to check the Driver Assistance system

A: Check Driver Assistance system

If Safe Exit Warning (SEW) detects a system fault, a warning message appears on the instrument cluster and the Master Warning Light illuminates for a short time.

Kia Sportage Master Warning Light indicator

Arrange for SEW to be inspected by a qualified workshop. Kia recommends contacting an authorised Kia dealer or service partner.

Kia Sportage instrument cluster message to check the outside mirror warning icon

A: Check outside rearview mirror warning icon

If a warning indicator in an outside rearview mirror is not working correctly, a message appears on the instrument cluster for a short time and the Master Warning Light illuminates.

Kia Sportage Master Warning Light indicator for an outside mirror warning fault

Have SEW inspected by a qualified workshop if this occurs. Kia recommends contacting an authorised Kia dealer or service partner.

Safe Exit Warning disabled

Kia Sportage instrument cluster message indicating that the rear corner radar is blocked

A: Driver Assistance system limited. Radar blocked.

Snow, rain or other material covering the rear bumper around a rear corner radar or sensor can interfere with detection. A trailer, carrier or similar attachment may also affect sensor performance and temporarily limit or disable SEW.

While the system is limited, a warning message and the Master Warning Light appear on the instrument cluster. This message does not necessarily indicate a fault in Safe Exit Warning.

After removing the obstruction or attachment, restart the Kia Sportage. SEW should then operate normally if the obstruction was the cause.

If Safe Exit Warning still does not work correctly after the obstruction or attachment has been removed and the vehicle restarted, have the system inspected by a qualified workshop. Kia recommends contacting an authorised Kia dealer or service partner.

WARNING

  • Safe Exit Warning may not operate correctly even if no warning message appears on the instrument cluster.

  • Shortly after start-up, SEW may not operate correctly if there are no detectable objects in the area, such as in open terrain, or if a detecting sensor is covered by foreign material.

CAUTION

Switch Safe Exit Warning off before fitting or using a cargo rack or other equipment. Remove the equipment before switching the system back on.

Limitations of Safe Exit Warning

Safe Exit Warning may not operate as intended, or may issue a warning unexpectedly, in the following situations:

NOTE

For precautions concerning the rear corner radars, refer to the “Blind-Spot Collision-Avoidance Assist (BCA)” section.

WARNING

  • Strong electromagnetic waves may interfere with SEW and prevent it from operating correctly.

  • Safe Exit Warning may be unavailable for approximately three seconds after the Kia Sportage is restarted while the rear corner radars initialise.

  • If an obstruction or system fault remains, restarting the vehicle will not restore normal SEW operation.

Safe Exit Warning operation. Warning
Warning Safe Exit Warning can alert occupants to a possible collision while they are preparing to leave the vehicle. The warning function is: Collision warning when exiting the vehicle ...
Blind-Spot View Monitor (BVM): (if equipped)
When you activate a turn signal, the Blind-Spot View Monitor (BVM) displays a camera image of the corresponding rear blind-spot area in the instrument cluster. The Kia Sportage uses a wide-angle ca...
See also:

Transmission shift indicator
The transmission shift indicator shows gear information for the transmission fitted to your Kia Sportage. Automatic transmission shift indicator: (if equipped) Figure 1. Ty ...

Components and Components Location
Components Location 1. Engine Control Module (ECM)2. Manifold Absolute Pressure Sensor (MAPS) #13. Intake Air Temperature Sensor (IATS)4. Manifold Absolute Pressure Sensor (MAPS) #25. Engine Coo ...

Rear Bumper: Components and Components Location
Components 1. Front bumper cover2. Front bumper side bracket [RH]3. Front bumper side bracket [LH] ...

Categories

Copyright © www.kispmanual.com 2014-2026 - 0.0585