Kia Sportage: Seat Belt Buckle Switch (BS): Description and Operation
Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Restraint / SRSCM / Seat Belt Buckle Switch (BS): Description and Operation
| Description |
The SRSCM shall monitor the status of the driver and front
passenger seat belt buckle. The SRSCM provides one pin each for the
driver and front passenger seat belt buckle status input. The seat belt
buckle circuit operates from internal boost voltage supplied by the
SRSCM, and uses chassis ground for the signal return. The buckle status
shall modify the SRSCM deployment. If the buckle status is unbuckled,
the corresponding pretensioner will not be deactivated.
Side Impact Sensor (SIS): Repair procedures
Removal
Pressure Side Impact Sensor
•
Removal of the airbag must be performed according to the precautions/procedures described previously.
•
Be ...
Other Information:
Tail Gate: Repair procedures
Replacement
Tail Gate Trim Replacement
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the relate ...
Fuel Tank Air Filter: Repair procedures
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Lift the vehicle with a jack.
3.
Disconnect the canister close valve connector (A).
4.
Disconn ...
Categories
- Home
- Kia Sportage QL (2015-2019) Owners Manual
- Kia Sportage QL (2015-2019) Service Manual
- Kia Sportage SL 2010-2016 Owners Manual
- Kia Sportage SL 2010-2016 Service Manual
Copyright www.kispmanual.com 2014-2026