Kia Optima Manuals

Kia Sportage: Seat Belt Buckle Switch (BS): Repair procedures - SRSCM - Restraint - Kia Sportage SL Service & Repair ManualKia Sportage: Seat Belt Buckle Switch (BS): Repair procedures

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Restraint / SRSCM / Seat Belt Buckle Switch (BS): Repair procedures

Removal
1.
Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2.
Remove the front seat assembly. (Refer to the Body group- Front seat)
3.
Loosen the seat belt buckle mounting bolt and remove the seat belt buckle switch.

Installation
   
Be sure to install the harness wires not to be pinched or interfered with other parts.
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
3.
Install the seat belt buckle switch.
Tightening Torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)
4.
Install the front seat assembly. . (Refer to the Body group- Front seat)
5.
Reconnect the battery negative cable.
6.
After installing the seat belt buckle switch, confirm proper system operation:
•
Turn the ignition switch ON; the SRS indicator should be turned on for about six seconds and then go off.
Seat Belt Buckle Switch (BS): Components and Components Location
Components ...

Passive Occupant Detection System (PODS): Description and Operation
Description The system is intended to classify the occupancy status of the front passenger seat in a motor vehicle based upon the measured force on the bottom seat cushion. The system also com ...

Other Information:

Intake Actuator: Repair procedures
Inspection 1. Ignition "OFF" 2. Disconnect the intake actuator connector. 3. Verify that the actuator operates to the recirculation position when connecting 12V to the terminal 3 and groun ...

Audio Remote Control: Schematic Diagrams
Circuit Diagram ...

Categories

Copyright www.kispmanual.com 2014-2026