Removal |
Take care not to damage and scratch the hazard lamp switch assembly and its related parts.
Apply the protective tapes to the hazard lamp switch assembly and its related parts. |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the crash pad passenger''s garnish (A).
(Refer to BD group - "Crash pad") |
3. |
Disconnect the connectors and remove the cluster fascia panel (A).
(Refer to BD group - "Crash pad") |
4. |
Remove the center fascia panel (A) after loosening the mounting screw (2EA). |
5. |
Disconnect the connector (A) installed on the center fascia panel. |
6. |
Remove the AVN assembly (A) after loosening the mounting screw (4EA). |
7. |
Disconnect the AVN connectors (A) and cable, then remove the AVN unit completely.
|
Installation |
1. |
Connect the AVN head unit connectors and cable. |
2. |
Install the AVN head unit. |
3. |
Install the center fascia panel. |
4. |
Install the cluster fascia panel. |
5. |
Install the crash pad passenger''s garnish. |
6. |
Connect the negative (-) battery terminal.
|
Fuel Filler Cap: Description and Operation
Description
A ratchet tightening device on the threaded fuel filler cap
reduces the chances of incorrect installation, which seals the fuel
filler. After the gasket on the fuel filler cap and t ...
SS-B Solenoid Valve(ON/OFF): Description and Operation
Description
SS-B solenoid valve is attached to the valve body and is an on/off solenoid valve that is used to change gears.
SS-B Solenoid valve(ON/OFF) is installed at valve body. ...