Inspection |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the front door trim and power window switch.
(Refer to the BD group - "Front door") |
3. |
Check for continuity between the terminals in each switch
position according to the table. If the continuity condition is not
normal, replace the switch. [Driver Auto Up/Down] |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the front door trim and power window switch.
(Refer to the BD group - "Front door") |
3. |
Check for continuity between the terminals in each switch
position according to the table. If the continuity condition is not
normal, replace the switch. [General] [Power Door Lock] |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the rear door trim.
(Refer to the BD group - "Rear door") |
3. |
Remove the rear power window switch module. |
4. |
Check for continuity between the terminals in each switch
position according to the table. If the continuity condition is not
normal, replace the switch.
[General] |
Placing a passenger seat belt into the auto lock mode
The auto lock mode will help prevent the normal movement of the child in the
vehicle from causing the seat belt to loosen and compromise the child restraint
system. To secure a child restraint s ...
Windshield wiper/washer
A : Wiper speed control
· MIST – Single wipe
· OFF – Off
· INT – Intermittent wipe
AUTO* – Auto control wipe
· LO – Low wiper speed
· HI – High wiper speed
B : Intermittent wipe time adjustme ...