Removal |
1. |
Lift up the vehicle.
(Refer to GI group - "Lift and support points") |
2. |
Remove the rear bumper.
(Refer to the BD group - "Rear bumper") |
3. |
Pull out the sensor by opening the sensor holder out. |
4. |
Disconnect the connector from the ultrasonic sensor. |
Installation |
1. |
Install the sensor and connector. |
Power Door Lock Actuators: Repair procedures
Inspection
Front Door Lock Actuator
1.
Remove the front door trim.
(Refer to the BD group - "Front door")
2.
Remove the front door module.
(Refer to the BD group - "Front door")
3.
Disc ...
Input Speed Sensor: Schematic Diagrams
Circuit Diagram
...