Kia Sportage: Thermostat: Troubleshooting - Cooling System - Engine Mechanical System - Kia Sportage SL Service & Repair ManualKia Sportage: Thermostat: Troubleshooting

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Engine Mechanical System / Cooling System / Thermostat: Troubleshooting

Troubleshooting
Symptoms
Possible Causes
Remedy
Coolant leakage
From the thermostat gasket
Check the mounting bolts
Check the torque of the mounting bolts
Retighten the bolts and check leakage again.
Check the gasket for damage
Check gasket or seal for damage
Replace gaskets and reuse the thermostat.
Cooled excessively
Low heater performance (cool air blows-out)
Thermogauge indicates ''LOW''
Visually check after removing the radiator cap.
Insufficient coolant or leakage.
After refilling coolant, recheck.
GDS check&Starting engine
Check DTCs
Check the fan motor performance as temperature varies.
Check connection of the fan clutch or the fan motor.
? If the fan clutch is always connected, there will be a noise at idle.
Check the engine coolant sensor, wiring and connectors.
Check the fan motor, the relay and the connector.
Replace the componants.
Remove the thermostat and inspect
Check if there are dusts or chips in the thermostat valve.
Check adherence of the thermostat.
Clean the thermostat valve and reuse the thermostat.
Replace the thermostat, if it doesn''t work properly.
Heated excessively
Engine overheated
Thermogauge indicates ''HI''
Visually check after removing the radiator cap.
Insufficient coolant or leakage.
? Be careful when removing a radiator cap of the overheated vehicle.
Check air in cooling system.
After refilling coolant, recheck.
Check the cylinder head gaskets for damage and the tightening torque of the mounting bolts.
GDS check&Starting engine
Check DTCs
Check the fan motor performance as temperature varies.
Check if the fan clutch slips.
Check the water pump adherence or impeller damaged.
Check the engine coolant sensor, wiring and connectors.
Check the fan motor, the relay and the connector.
Replace the fan clutch, if it doesn''t work properly.
Replace the water pump, if it doesn''t work properly.
Immerse the thermostat in boiling water and inspection.
After removing the thermostat, check it works properly.
? Check the thermostat opens at the valve opening temperature.
Replace the thermostat, if it doesn''t work properly.

Thermostat: Repair procedures
Removal and Installation     Disassembly of the thermostat would have an adverse effect, causing a lowering of cooling efficiency. Do not remove the thermostat, even if ...

Lubrication System
...

Other Information:

Seatback angle
To recline the seatback: 1. Lean forward slightly and lift up the seatback recline lever. 2. Carefully lean back on the seat and adjust the seatback of the seat to the position you desire. 3. R ...

Water pump: Repair procedures
Removal and Installation 1. Loosen the drain plug, and then drain the engine coolant. Remove the radiator cap to drain with speed. 2. Remove the drive belt (A) after turning the drive belt ten ...

Categories


Copyright © www.kispmanual.com 2014-2025