Inspection |
1. |
Check the continuity between the terminal and the body with an ohmmeter.
If there is no continuity, replace the oil pressure switch. |
2. |
Check the continuity between the terminal and the body when
the fine wire is pushed. If there is continuity even when the fine wire
is pushed, replace the switch. |
3. |
If there is no continuity when a 50kPa (0.50kgf/cm?, 7.25psi) is applied through the oil hole, the switch is operaing properly.
Check for air leakage. If air leaks, the diaphragm is broken. Replace it. |
Start/Stop Button: Repair procedures
Removal
1.
Disconnect the negative(-) battery terminal.
2.
Remove the cluster fascia panel.
(Refer to the BD group - "Crash pad")
3.
Disconnect the connector (A).
4.
Remove the start ...
Closing the hood
1.Before closing the hood, check the following:
All filler caps in the engine compartment must be correctly installed.
Gloves, rags or any other combustible material must be removed from the
...